In addition to the ink refill, which can damage the printer is humidity in the room inkjet printer that is caused by the remaining ink is removed in the bottom of the printer with media-sponge absorber. If the printer used to print, the printer into exile because of wet ink and the humid conditions, fungus, and eventually cause corrosion can cause the printer components made of iron and the age cut-use printer.

So that the age-use Epson printers more durable, it’s been opened since the first channel ink residue disposal (waste-ink) directly exit the printer body. So that does not make a sponge to absorb ink resulted in a wet and humid. And the regular waste-ink counter reset in software by using the appropriate type of inkjet printer, so that the printer can still be used permanently.

Here is the procedure to create the necessary channels disposal:

3 Piece Tools and Materials needed:

1. Plus large screwdriver and a small minus screwdriver.
2. Small plastic bottle that is easily tied to the printer body.
3. Wire to bind or rubber waste-ink bottle to the printer body.

B. Procedure remove Casing and Install The Ink Bottle:

1. Release 2 piece screw on the back of the printer.

2. Remove the lock casing on the right side of the body and left the printer, using a small minus screwdriver, the lever toward the outside.

3. Press to the outside, lock the casing in the back of the paper feeder. There are 4 pieces hook fastener. Be careful not to fracture. Then slide to the front of the printer, remove the hook for fastening the front of the printer casing.

4. Remove the hose line out to the ink-Absorber Sponge, as in the following picture: As should be free, to be able to be outside the body.

5. Prepare the ink bottle plastic container remaining. Clean, if you use bottles used. Cut-out plastic bottle nosel page, so that the hose out in the ink can freely insert into the bottle cap page. Fasten a small wire rack in the printer body to the left of the back (see picture)

6. Replace the printer casing body along with the insert-lapse waste ink right on the top of the plastic bottles. be dilated slightly ventilation grille printer, so that the lapse of the wall and the ink does not easily flow out.

7. Insert the tip of the hose into a plastic bottle cap, such as in the picture. Try Head Cleaning. Some of the ink remaining in the pump to be in plastic bottles.